I just picked up a couple of 9100s with problems. One hangs up in memory test. I'm thinking it may not have the dip switch settings set up right. I've searched and searched but can't find the settings in the documentation. I'd appreciate it if someone could send them to me or point me to a manual that has them. The second one doesn't even get that far. It hangs up with no display and the Run UUT and Disk Access LEDs lit. Any ideas on how to get these running would be appreciated. Mark Hooks _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
Mark, Try the Service Manual Part 2, page 3-25, Table 3-6. It has the config switch settings for various RAM sizes. Have a Merry Christmas All. Dave ----- Original Message ----- From: "Mark Hooks" <markhooks@earthlink.net> To: "Techtoolslist" <Techtoolslist@flippers.com> Sent: Sunday, December 24, 2006 2:00 AM Subject: [Techtoolslist] Fluke 9100 Woes, Memory Dip Settings Needed
I just picked up a couple of 9100s with problems. One hangs up in memory test. I'm thinking it may not have the dip switch settings set up right. I've searched and searched but can't find the settings in the documentation. I'd appreciate it if someone could send them to me or point me to a manual that has them.
The second one doesn't even get that far. It hangs up with no display and the Run UUT and Disk Access LEDs lit. Any ideas on how to get these running would be appreciated.
Mark Hooks
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
At 2:00 AM -0500 12/24/06, Mark Hooks wrote:
I just picked up a couple of 9100s with problems. One hangs up in memory test. I'm thinking it may not have the dip switch settings set up right. I've searched and searched but can't find the settings in the documentation. I'd appreciate it if someone could send them to me or point me to a manual that has them.
The second one doesn't even get that far. It hangs up with no display and the Run UUT and Disk Access LEDs lit. Any ideas on how to get these running would be appreciated.
Mark Hooks
If you have the CPU extension service board you can test the 9100s with a working unit and a 68000 pod. I believe Art (fromny) has these 9100 series extension cards in stock - they normally came with the unit when it was bought, but they tended to separate over time... John :-#)# _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
participants (3)
-
David Fish -
John Robertson -
Mark Hooks