On 04/21/2014 12:19 PM, Grant Thienemann wrote:
Hey Guys,
I'm bound and determined to get my Berzerk working again. Currently I have it working to the point that the game will boot however the game will freeze randomly. List of things I have done:
New sockets on the ZPU-1000 with new EPROMs and Z80 processor New ram sockets on the VFB-1000 and I have 4164 ram and 4116 ram that I'm looking into putting onto the VFB-1000.
The BSC-1000 color board is fine, and the cleanest board I have on the machine.
When I go to do the short ram check on my Berzerk board set, the 0-7FF fails, however the second one, 1000-17FF if I remember passes correctly.
If anyone knows any tips or tricks with using the Fluke 9010a with a Berzerk board set I would appreciate it.
Thanks Grant ____________
If the RAM test fails in one section, but not another then you likely have a problem with a RAM chip. If you have 4-bit chips then you can tell which it is by the error code - if it is X- that is the High 4-bit RAM, and if it is -X then that is the low 4-bit RAM. Where "X" indicates the bad read. I use "55" and "AA" write then read to suspect RAM and this can show up the errors a bit faster. Say you write 55 and then read 51 - that means the lower 4-bit RAM has a stuck bit (Bit 3 always low). Now you may get 55, so then you try AA which may give you A2 and again that indicates a bad lower RAM Bit 3. John :-#)# -- How to subscribe or unsubscribe from TTL http://seven.pairlist.net/mailman/listinfo/techtoolslist _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/