On Tue, Dec 8, 2015 at 9:04 AM, Tony Jones <tony@tonyjones.com> wrote:
On Tue, Dec 8, 2015 at 8:36 AM, Steve Larkins <steve@ukaudiovisual.co.uk> wrote:
I am running the image on an SD card using the scsi SD adapter made by that cleaver Australian guy linked to and spoken about on this very list.
Make sure you have updated the BIOS chip if you are using a 9100a as the early released did not support the software the later image was made from.
I'm using a 9100FT. Not a 9100A. Already has v1.3. i was not sure if v1.3 was the latest, I now know that it is.
I'll debug things further, sounds like the image should be working.
No luck getting the image working. Is there any info on what I should be seeing during the format process? I couldn't see anything in the documentation scans. I was able to make a v1.4 service disk but all I'm getting during the disc format is a blank screen and a seemingly endlessly flashing "Disc Access" light. Access LED on the SCSI2SD never illuminates. One time, after about 30 minutes all of a sudden the Busy/Stopped and More softkeys/More information LEDs started cycling. I pressed a key and got a beep and it went back to blinking "Disk Access". Still blank screen. I have two 910xFT units, both behave the same way. Swapping SCSI cards between units, no change. SCSI2SD and Fluke both are set to 512kb sectors. SCSI2SD is definitely good, as is SCSI cable when hooked to a PC. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/