Marc, I just found some of my notes on the floppy replacement. I think I ended up using the Canon HD option but I made some note about the TEAC FD235 so I'm not 100% sure. The replacement drive I used was the actual HxC floppy emulator from lotharek.pl. Since you can run the HxC firmware on the GoTek though I would think it should work the same way. I have my bench apart at the moment but if needed I can setup the 9100 and boot it with the service disk this weekend and take a look. Thanks,-Chris
On Tuesday, March 17, 2020, 10:42:59 PM EDT, Marc Desfossés <mdesfoss@hotmail.com> wrote: > > > >Hi Chris,>>I am using the Sony type. Do you remember what your HxC setup is using ?>>Marc>>De : Techtoolslist <techtoolslist-bounces@flippers.com> de la part de Chris Loggans via Techtoolslist <techtoolslist@flippers.com> Envoyé : 17 mars 2020 21:32 À : Technical Tools Mail List <techtoolslist@flippers.com> Cc : Chris Loggans <cloggans@yahoo.com> Objet : Re: [Techtoolslist] Fluke 9100A - Cannot boot from system disks> >Mark, When you use the service disk, what type of floppy drive is your 9100 set up for? It’s been a while since I did the HxC floppy conversion on mine but I seem to recall getting >strange errors if the wrong floppy model was selected. Chris
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/