William Stillwell writes:
Did you verify the address of the fluke?
I set it to 3, as the SPECTRUM-TX README said. Since it enters remote control mode when I launch the PC program and leaves when I close it, I think it’s receiving commands from the PC. I haven’t worked with GPIB before, so I’m not sure if there’s something else I can do to verify this. There’s a "GPIB Spy" program in the NI driver package, which purports to monitor the bus. I ran it, but it didnt’t capture anything. Maybe it only sees things sent by other devices, not the machine it runs on? -- Ian _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/