Hello Rodger, You are correct I should replace them asap. Thanks for pointing this out. Best regards, Filip ----- Original Message ----- From: "Rodger Boots" <rlboots@cedar-rapids.net> To: "Technical Tools Mail List" <techtoolslist@flippers.com> Sent: Monday, October 31, 2005 10:40 PM Subject: Re: [Techtoolslist] Fluke 9010A Input voltage
Be careful, a lot of times when you change voltage you also should change the fuse. In the case of the 9010A the line fuse should be 1A fast blow for 120 V and 1/2 A fast blow for 240 V.
Filip Hautekeete wrote:
Hello Steve,
You are correct. Thanks to John Robertson I figured out there is a slide card for voltage selection behind the fuse panel. No need to drag the systems out of your garage ;-)
Thanks for your help!
Filip
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist