I've been helping a friend setup a Pinball repair business in Ottawa, but he was reaching a crisis in which he was forced to swap-in known-good MPUs for bad ones, with the "bad" pile starting to get out of hand, since his technician was struggling to repair them. But then I thought about my 9010A setup. After many years just gathering dust in my basement, I finally got off my butt and got my 9010a with 6800 pod setup and used it to restore full functionality to a bunch of these dead Bally and Stern Pinball MPUs. I was most impressed with how the 9010a helped me isolate the problems with these boards! My friend would now like to extend this approach to Gottlieb and Williams pinball MPUs, but as I only have the 6800 pod, looked into getting more pods. I found that in the last few years, the supply of pods on ebay at least seems to have dried up. I am looking for 6502, 6802 and 6809 pods. Would anyone on the list be able to help me out by selling me any of these pods (obviously, working condition is _vastly_ preferred!). An aside: Is it possible to convert my 6800 pod to run with one of the other CPUs? I'm not familiar with the details, but vaguely recall that one can substitute CPUs on some pods. Please email me if you have one of these pods sitting idle, and would be willing to sell it. Thanks so much! grant.. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/