Data I/O 29B and Unipak 2B problem loading RAM from serial port and Promlink
When I load RAM from Master, the PROMs burn fine. When I load RAM from a disk file, it stops at 100% and says 'Waiting on programmer...' (or very similar words to that effect) and sits there until I cancel it. Any ideas? Promlink appears to be controlling the 29B fine because verifies, burns, etc from a master PROM work fine. Any ideas? _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
Do you have all the RS-232 signals that the 29B uses hooked up? John :-#)# At 6:52 PM -0600 3/20/05, Robert C. Bullock wrote:
When I load RAM from Master, the PROMs burn fine. When I load RAM from a disk file, it stops at 100% and says 'Waiting on programmer...' (or very similar words to that effect) and sits there until I cancel it. Any ideas? Promlink appears to be controlling the 29B fine because verifies, burns, etc from a master PROM work fine.
Any ideas?
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist
participants (2)
-
John Robertson -
Robert C. Bullock