I have a couple of dead floppies on my 9100's and was wondering if anyone knows how to set up a 1.44 to run on them. The Drive Select has to "0", but then nothing much happens. The latest version of the System setup disc (Rv1.4 - for SCSI) seems to support the Canon HD drive but I have no idea what drive that was supposed to be. The drives supported (Rv1.4) are: Canon (MD350) Sony F17 TEAC FD235 Mitsu(mi?) MF355C Canon HD (unknown model) The service manual says (Pg 3-34) that the floppy control lines are: DS0, DS1 (Drive Selects - D0 for 9100) Spare (not used - is this the High Density enable?) MINI (selects floppy clock speed for 5-1/4 & 3-1/2 or 8") DENS (single or double density - but how does this fit in with a Canon HD drive?) P0, P1 (write pre-compensation time 0, 125ns, 250ns, or 375ns) EN-ENT (Floppy Interrupt) Anyone have info on any of these drives and can identify the parameters needed? Thanks! John :-#)# How to subscribe or unsubscribe from TTL To do either you send email to "MajorDomo@flippers.com" and in the body you state either "Subscribe techtoolslist" or "Unsubscribe techtoolslist", note that the Subject is "" (Blank)... FTP site is: ftp://ftp.flippers.com/TTL/