I have a couple of dead floppies on my 9100's and was wondering if anyone knows how to set up a 1.44 to run on them.  The Drive Select has to "0", but then nothing much happens. The latest version of the System setup disc (Rv1.4 - for SCSI) seems to support the Canon HD drive but I have no idea what drive that was supposed to be.

The drives supported (Rv1.4) are:
Canon (MD350)
Sony F17
TEAC FD235
Mitsu(mi?) MF355C
Canon HD (unknown model)

The service manual says (Pg 3-34) that the floppy control lines are:
DS0, DS1 (Drive Selects - D0 for 9100)
Spare (not used - is this the High Density enable?)
MINI (selects floppy clock speed for 5-1/4 & 3-1/2 or 8")
DENS (single or double density - but how does this fit in with a Canon HD drive?)
P0, P1 (write pre-compensation time 0, 125ns, 250ns, or 375ns)
EN-ENT (Floppy Interrupt)

Anyone have info on any of these drives and can identify the parameters needed?

Thanks!

John :-#)#

How to subscribe or unsubscribe from TTL

To do either you send email to "MajorDomo@flippers.com" and in the body you state either "Subscribe techtoolslist" or "Unsubscribe techtoolslist", note that the Subject is "" (Blank)...

FTP site is: ftp://ftp.flippers.com/TTL/