At 01:03 AM 11/01/2002 -0600, you wrote:
The Fluke cannot be used as an EPROM emulator. The pods have no ram (to speak of), and execute code out of the target board's program store. You could make a pod which served that function, but why bother when there are so many already out there.
It's an interesting topic, though, and I'm curious what exactly the need is. The Fluke can store a fraction of someone's EPROM code and it can even be used as an in-board EEPROM/FLASH EPROM programmer, flashing boot code into boot sectors or application sectors if someone wants. But I missed the original thread, alas. }:-} What exactly is the desired application? I can't think of any way to make it emulate a UUT's EPROM unless it's Z80 code that doesn't access I/O devices. --- Mr. Rice may leak or explode if recharged or inserted improperly. To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.
The Fluke cannot be used as an EPROM emulator. The pods have no ram (to speak of), and execute code out of the target board's program store. You could make a pod which served that function, but why bother when there are so many already out there.
The 32 bit pods have the ability to do EPROM emulation. I have one for 68020 and another for the 80486. Both have several "ROM MODULES" that attach and allow 28/32 pin EPROMs to be emulated as well. If anyone has interest in either module, please let me know. I'd be interested in selling/trading. To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.
Fredic, Are you familiar with the rksic.exe 9010A editor/compiler/up/downloader? I was wondering if you had any documentation on it as we have nothing...
-- Mr. Rice may leak or explode if recharged or inserted improperly.
We shall endeavor not to recharge you improperly... Thanks, John :-#)# To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.
Dear Fredic, I know you are busy, but I would like to ask your permission to recompile your source code for the 9010 to a more modern windows style interface. i would be willing to share the results of the code with TechToolsList folks and you can look it over before I send it out to anyone, or you hold and release it to those as you see fit. I was hoping to spread the cost of the programming over a few fellows in the group you see... My idea is to have a fellow I know set it up to run not unlike a simple word processor with the ability to "print" to the RS-232 port. Sincerely yours, John Robertson
participants (6)
-
Corey Stup -
Fredric L. Rice -
jess askey -
John Robertson -
Kev -
Mark Shostak