Cameron Rector wrote:
Hello all, I am new to this site, so I will applogize for dumb questions up front.
I have a Bytek fireman 8x and I am having trouble programming TMS2532A's. The programming part goes well until verify. It seams that at address 0800h it fails. It does this on every chip I try. I don't know if this could be a configuration setting or it the unit has a bad solder joint or IC. I did a visual inspection from A11 pin 18 back through the circuit traces and joints, however I didn't find anything wrong. I tried to call Bytek and their phone is disconnected and my email bounced back.
So, does anyone here know anything about this machine? Does anyone know where I can get the schmatic's for this programmer?
I am a newbe at programming eproms, so don't overlook the fact I could have a software setting wacked out.
The first verify error says "ADDS 0800h Ram 01 Device 00"
That's OK, the last address in a 2532 would be 07FF, so at 0800 you're no longer inside the 2532. You have the end of buffer set too high, otherwise it would have stopped at 07FF. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist