Thanks Kev, Too many accounts... If anyone is typing these 9010A test routines in, look out for some typos in the original FLUKE service manual. As an example, if you see any lower-case text that appears to be in the code area, it is just overflow from the right side comments - ignore them. I have entered a number of the programs, it is just the ones that have not been filled in that remain to be entered. If you compile every now and then you will catch the typos, and if using rksic remember that program order MATTERS. The manual shows PROGRAM 8 listing before PROGRAM 7 for the RS-232 code, but it MUST be entered in PROGRAM number order, so 7 is entered before 8...or you get an error that might take you a few minutes to figure out. I have also examined the programs in the file FLUKE_TAPES.ZIP and program 2 or 4 have a nice little Address line identifier routine about 1/2 way down, and also a DATA line one as well. Not as good as some, but a start... See FILE02.S for notes. http://www3.telus.net/Flippers/Fluke John :-#)# At 11:12 AM 11/02/2002 -0500, Kev wrote:
John ment to type....
http://www3.telus.net/Flippers/Fluke
...w3.telus.net/Pinball/Fluke and the file is 9010test.s (source) and .h (hex). I have also uploaded just the RS-232 test RS232TST.S
To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.