I have had some luck re-soldering all the pins on the inter-board connectors - no experience with this particular pod/problem though Art ----- Original Message ----- From: "Andre Huijts" <a.huijts@upcmail.nl> To: "Technical Tools Mail List" <techtoolslist@flippers.com> Sent: Sunday, November 18, 2012 4:13 PM Subject: [Techtoolslist] 6502 pod error code OK.... Something I noticed when checking once again my 6502 pod is that the interconnecting pins between the two boards seemed very loose on one side (the more near the lowest part of the pod). I tried to connect them as tight as possible but the spacer near where the ground connection of the flat-cable is placed prevents it to fit really tight. I have a feeling there is still not a good/reliable connection between the boards this way. When I connect it now and run the self-test I get this error: Add line AB12 pin 22 not drivable Neither the original pod manual nor the additional Pod info for the 9100 indicate this error code and what it means. It is clear enough I guess but what do they mean with AB12 ? André Huijts andre.huijts@upcmail.nl _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org Archive site: http://seven.pairlist.net/pipermail/techtoolslist/ _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org Archive site: http://seven.pairlist.net/pipermail/techtoolslist/