On May 17, 2017, at 8:18 AM, Tony Jones <tony@tonyjones.com> wrote:
On May 16, 2017 11:46 PM, "Ian Eure" <ian@retrospec.tv> wrote:
Whoops, correcting this link. It’s https://github.com/ieure/fluke -9100-disk-archive
Regarding the contents of the readme file. None of the following was required for my 9100FT or 9105FT. The SCSI2SD is self-terminating so I'm not sure what the rationale is for the insertion of a additional drop/terminator..
"For 9100FT units only: - Replace the SCSI cable with one having three connectors. - Plug a terminator into the far end of the cable. - Remove the the terminating resistor packs from the SCSI2SD"
I'll revisit this, but I had issues on my FT when using the built-in termination & in pretty sure it was you who told me you'd also had problems & found that an external terminator was required by contacting the designer of the board. It's certainly possible that I had some other configuration issue at the time, so I'll recheck to see what the situation is. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/