If you have the extension socket (Instrument Accessory #9000A-7201), then you can check the voltage(s) as connected to the pod.
Afraid I don't have that.
It is possible that you have a bad connection at the UUT socket, isn't it? You have run the pod self test and wiggled the cable while under self test?
Tried all that - besides which, I've only just put a new CPU socket onto the N.D. board as it was impossible to plug the Fluke into the original socket. The 6502 CPU works fine in the new socket, but the Fluke 6502 pod won't (yet it works on other 6502-based boards). I'm sure the socket and contacts are fine. Phil _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist