Joe, Thanks for the great info. James Marous was kind enough to send me a manual for the 5006A which I will be scanning over the next couple days. In it, I saw some expanded views of all of the parts and now understand what you were talking about :) It looks like all I need are the 5 grabbers and a single wire (which I assume connects to the main probe?). Could you point me to a specific place to get these? That SkyCraft store didn't appear to have a web page. Thanks, Jon At 06:16 PM 2/22/2000 -0500, Joe <rigdonj@intellistar.net> wrote:
Do you have the wires on your pod or does it just have sockets? The wires have a small female socket on one end and a large male pin on the other. You can use the small female socket directly on wire wrap pins, header pins and the like or you can use "grabbers" with them. The wires and grabbers from the HP 5001 MicroProcessor Exerciser and the HP 1600, 1601, 1607, 1610 & 1615 logic analyzers will fit. The grabbers are also interchangeable with the ones from the Gould and some other brands of Logic Analyzers. Most of them have a hole with a single male pin inside. The wire pushes onto the pin and the grabbers are similar to the E-Z hooks. You can usually find the wires and grabbers in electronics surplus stores, I got piles of them from SkyCraft in Orlando.
To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.