Just started using my Fluke for the first time. Decided to work on a Sea Wolf that quit working on me. Ran a bus test, which came back fine. Then did a short RAM test, and got the following errors: Range 0000-1fff R/W ERR @ 0000 BTS FF - loop? Range 2000-3fff RAM DCD ERR @ 2000 Bit 11 - loop? Range 4000-5fff R/W ERR @ 4000 BTS FF - loop? Looking into the manual, I found the errors, but not quite sure what they are telling me. I somewhat get the RAM DCD error. It's saying at 2000 there is a problem with the address 11, which would be pin 3 on the RAM. Is that correct? One of my questions, is how do you know what RAM goes with what error? If there are 16 RAM chips on the main pcb, how do you tell which ones are between 0000-1fff and which one goes with 0000? Not sure what the R/W error is stating. Any help would be greatly appreciated. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/