Have you tried using it "blind"? Maybe run a bus test but intentionally short two data or address pins together so it fails and then requests looping - tap "yes" after the beep then see if the looping led turns on. This raises a good question if it is the display: Has anyone worked on or worked out an LED display replacement solution yet? Best Regards, Bill -----Original Message----- From: Techtoolslist [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Dave Riddle (Technical Dept.) Sent: Tuesday, August 08, 2017 3:48 PM To: robert via Techtoolslist Subject: Re: [Techtoolslist] fluke 9010a not booting Open filament in the display tube? Look at it in the dark for tiny red stripe. On 8/8/2017 3:05 PM, robert via Techtoolslist wrote:
my fluke 9010a rev 3a is not booting the diplay doesnt go on i think its a watchdog problem i have the service manual but it doesnt seem to cover the 3a rev firmware for the rom signatures all my power test points are good and also i get a beep when power on but no display does anyone have any idea what could be the cause of the shutdown _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/ --- This email has been checked for viruses by AVG. http://www.avg.com _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/