I think the pinouts I saw archived below, though they may work?, could cause damage to the 9010A or com port on the PC, as the handshake lines are wired as two outputs shorted together. Measuring the unconnected pins on both units showed that 4-RTS and 20-DTR were live outputs out of the 9010A, so connecting them to outputs on the PC may cause some problems. I just got mine working with this pinout: DB9 Female to PC DB25 Female to 9010A 1 CD input 2 RX input ------------2 TX output 3 TX output------------3 RX input 4 DTR output--------------------\ 5 GND-------------------7 GND | 6 DSR input --------------------/ 7 RTS output----\ 8 CTS input ----/ 9 RI input 4 RTS output 20 DTR input and it works at 2400,N,8,1 at least, obviously no hardware handshaking may limit the transfer speed, I will try higher. I just used the old Windows 3.11 Terminal program and sent the galaga.h file successfully. Now the big question! What do I press to run the script/tests? I'm trowelling through PDF files but won't have time to read it all for a couple of days, and haven't found the right pages yet, arrghh :) I understand the script, just not how to run it all, and what to do with each test and failures, etc. Ahh, I just worked out some of it, EXEC, ENTER/YES, etc.. Any tips and steps anyone has would be great, examples of a board test and repair from turn-on to finish, anything.. I will put it into a 'Getting Started' doc, c'mon guys! :-) Thanks, Marc ----- Original Message ----- From: "Kev" <KKlopp@erols.com> To: <TechToolsList@flippers.com> Sent: Monday, February 11, 2002 4:21 AM Subject: Fluke <> 232
Okay I finally got my Fluke 9010A talking to the PC.
Cable is
DB9 <-> DB25
2 2 3 3 4 20 5 7 7 4
For some reason I can only get
7, E, 1, 9600 (or slower to work)
I can not get 8, N, 1 to work properly?
Kev
To UNSUBSCRIBE from techtoolslist, send a message with "UNSUBSCRIBE" in the message body to: techtoolslist-request@flippers.com. Please direct other questions, comments, or problems to jrr@flippers.com.