Flip the 9100 upside down, there are five screws to remove, two on each outside edge and one near the center front of the underside of the case. Then flip the 9100 back to normal, and separate the beige painted cover from the beige plastic front by sliding it up, then tilt the cover to the left and set on it's side. When re-assembling take care not to pinch the hard drive cable! John :-#)# PS, Have you got any floppies that are not archived for the 9100? Need the V6.0 Service disk. At 03:30 PM 02/10/2002 +0100, Andy Welburn wrote:
hi all..
I have rebuilt my jamma test rig externsively today to incorporate it inside my vector rig.. i'm getting there...
anyway.. my 9100 sits on top of it, and seing as i had the whole lot to pieces today i thought i might as well dust out the 9100, clean the filters or whatever...
Now, i really don't want to break it as its vital to my work, however i couldn't for thel ife of me figure out how to get the damn case off...
i don't have the manuals to hand, they are in storage.. but i can't see how it comes apart..
can anyone help? :)
andy