24 Apr
2005
24 Apr
'05
10:42 p.m.
Hit setup on the 9010, hit more until you get to 'set trap active force line' set it to 'no' .. no >need to disable WD.
Assuming the reset signal is only used to reset the micro. If it goes to other registers, etc you could run into problems getting the board to run. -Adam ==================== http://www.onecircuit.com ==================== _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist