Ok, this thread is fun. :-) My turn: Fluke 9010, with probe, RS-232, Z80, 6502, 6809, 8088 pods and compiler Tektronix 1240 Logic analyzer, one 9-channel and one 18 channel card + pods, RS-232 Tektronix 1241 Logic analyzer, on 9-channel and three 18 channel cards + pods, RS-232 Tek 1240 Mnemonic/expansion packs: Z80, 6502, 6809, 68000, 68HC11, 8088, 8086, serial, parallel, etc. American Arium ML4400 Logic Analyzer w/ 68000/68040 pod and mnemonics American Arium ML4400 Logic Analyzer w/ misc pods and all mnemonic loads through 80486 American Arium Z-80 ICE (broken cable... grrrr.) HP 5004 signature analyzer Tektronix TDS220 100MHz digital scope Tektronix TDA720 100MHz hand-held scope Tenma 40MHz analog scope with cursors B&K 20MHz analog scope with component tester (like a tracker) Huntron Tracker 4000 EMUP Device Programmer EPP 8-gang EPROM programmer PicStart Plus (Pic programmer) Atmel AVR programmer Xilinx JTAG programmer Vantis JTAG programmer Lattice JTAG programmer Ceibo Philips 87LPC76x ICE Philips 87LPC76x programmer (you can never have enough programmers around. ;-) CST-700 RAM tester (4116 to 4Mbit tester, but no software for anything smaller than 4164.... grrrr.) OK Industries 9000 Microprocessor Controlled Fluid Dispenser (for solder paste) OK Industries Hot-air solder pencil OK Industries SMT solder-tweezers OK Industries vacuum-pick Metcal SST-01 Iron and tips Weller 4424 solder/desolder station Weller Fumex solder fume extractor PACE MBT solder/desoldering station Intel USB microscope (way entertaining! cheap surface mount inspection...) Hakko 850 Hot-air rework station Chip Level Designs Super Nintendo ICE Romulators (Genesis and SNES-- going to try to build some 16-bit wide ROM emulator adapters) Acer 7013 VGA multisync (works at 15KHz) that refuses to die no matter what I do to it. Fluke 77 meter, etc. PC's to talk to everything Stanley 18oz framing hammer (solves *multitudes* of PCB problems at 3AM) -Clay