9020A via IEEE-488?
I recently acquired a 9020A with a IEEE-488 interface and wondering if anyone has documents for using this configuration. I found the 9010A vs 9020A differences document from Fluke, but I'm not sure what software was used to control the 9020A via the 488 bus. I would be interested in the service manual and operating manual for the 9020A if anyone has spares too please. thanks. _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Nigel, is the 9010A vs 9020A differences document from Fluke in the ttl archive ftp site ? i am interested in reading this doco. if not, any chance you could send me a copy of it ? Also, any luck with control software for this via the iee488 i/f ? doing a little research, there is a USB to ieee488 interface board link here: http://galvant.ca/shop/gpibusb/ at a low cost. looks like this is used as a serial interface (pcb does the rest) so could use any serial software such as putty maybe ? i havent tried this myself - i am going to try piero's rs232/usb interface for the 9010a first to see if my 9020a recognises it. cheers andy _______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com https://pairlist7.pair.net/mailman/listinfo/techtoolslist FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
participants (2)
-
Andy Smout -
Nigel Williams