Chris,
What’s the cpu? The service manual shows “536094” but not too sure if this is a Fluke part number or what? Is that the actual number on the cpu?
Just read through some interesting stuff on the tape drives in the service manual so I may open mine up at some point and see if I can work out what’s up with the drive. Used to work fine until it was stored for a few months. When it came out of storage it no longer works. Never really bothered about it too much since I have the RS232 option but it would be nice to get it going again!
Martin.
On 19/11/06 12:47, "Chris Toseland" <Chris@muppzlab.co.uk> wrote:
Hi folks,
This maybe a long shot but does anyone have or can duplicate the controller CPU for the tape drive unit on a 9010?
My tape unit doesn't work, I've checked the sensors and even tried driving the CPU input pins directly all to no avail so I and can only assume that the CPU is dead.
Thanks
Chris
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
--
Guddler's Domain
http://www.guddler.co.uk