Hi Filip,

On all the 9010A's that I've seen (15 or so), on the rear where the international style power cord plugs in, there is a fuse under a plastic cover just below the socket. This also allows you to set the voltage with a slip in card.

Quoting from the 9010A Operator Manual: (find yourself a copy! or download it)

Line Voltage Selection (page 2-1)

yada, yada, yada.

1. Remove line fuse (slide cover up - JR)
2. Using a pair of needlenose pliers (see Figure 2-2), pull the line voltage card straight out.
3. Turn the card and insert it into its slot so that the value if the desired line voltage is the upper value facing the fuse slot. In Figure 2-2, the card is oriented to select 120V.

John :-#)#

At 8:08 PM +0100 10/31/05, Filip Hautekeete wrote:
Steve,
 
There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.
 
Best regards,
 
Filip
----- Original Message -----
From: Steve C
To: 'Technical Tools Mail List'
Sent: Monday, October 31, 2005 7:59 PM
Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

Yes, there is a panel on the back that allows voltage selection ö I canāt remember how but it was easy.

Steve
 
-----Original Message-----
From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
Sent: 31 October 2005 13:27
To: techtoolslist@flippers.com
Subject: [Techtoolslist] Fluke 9010A Input voltage
 
Hi all,
 
Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?
 
Best regards,
 
Filip
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist