Ahhh& I have the GFI option on this Fluke. The GFI switch was set to onand when I switched it offI got a different start up message, and the AUX I/F started working as documented in the manual.

 

I was able to submit by program via the RS232 cable.

 

JB

 

--James Bright
www.QuarterArcade.com
Restored Arcade Games for your Home

 

-----Original Message-----
From: owner-techtoolslist@www.flippers.com [mailto:owner-techtoolslist@www.flippers.com] On Behalf Of John Robertson
Sent: Thursday, March 20, 2003 2:50 PM
To: James Bright; techtoolslist@flippers.com
Subject: Re: Getting started with the Fluke 9010A

 

You need to test the RS-232 port. I think that info is in the 9010A Service manual, you can either type it in or grab that from the FTP site... check at the bottom of this email for info on how to get there...

John :-#)#

At 12:24 PM 20/03/2003 -0500, James Bright wrote:


 
Hey all. First time posting to this list. I haven't seen many posts recently, but I am starting to use a Fluke 9010A. I've been spending a lot of time reading the manuals, but of course I'm also playing with the Fluke to get some "hands on" experience. I'm trying to write a simple "Hello World" type of program to make sure my computer and Fluke are set up correctly and communicating.
 
I'm using the RKSIC program and believe that I have the COM port settings matching the fluke settings. I have compiled my simple program and I am attempting to load the programmer. RKSIC says to press the "AUX I/F" , "READ", "YES." When I press the AUX I/F button, I get a message saying "NO IO INFO." Is this correct? I wasn't able to successfully program the unit. When I follow the instructions from the RKSIC program, I end up with a "9000A REMOTE MODE ERR091." It seems like the Fluke isn't set up to receive the program correctly. I need to confirm that the pinouts of the serial cable are correct (I believe they are). My firmware version is 2.0, displayed on boot up. This may be a little old. (I'm worried that the documentation won't match the messages I see.)
 
Am I sending the program correctly? Or do I need to set up something else on the Fluke?
 
Thanks in advance. I'm hoping to spend more time with it this weekend using the 6502 pod.

JB
 
--James Bright
www.QuarterArcade.com
Restored Arcade Games for your Home

How to subscribe or unsubscribe from TTL

To do either you send email to "MajorDomo@flippers.com" and in the body you state either "Subscribe techtoolslist" or "Unsubscribe techtoolslist", note that the Subject is "" (Blank)...

FTP site is: ftp://ftp.flippers.com/TTL/

How to subscribe or unsubscribe from TTL

To do either you send email to "MajorDomo@flippers.com" and in the body you state either "Subscribe techtoolslist" or "Unsubscribe techtoolslist", note that the Subject is "" (Blank)...

FTP site is: ftp://ftp.flippers.com/TTL/