Just to be clear· any script generated by tech.quarterarcade.com (I am assuming this is what Tony means by ãtried to get the outrun script from fide to runä) should be looked over by the operator and adjusted appropriately. Itâs just a starting point, and it is frequently incorrect because the virtual machines in MAME arenât 100% accurate. Also, the script generator isnât smart enough to always generate legal subroutine names· thatâs what you get for free web-based utilities J

I think this was covered before, but based on recent postings, Iâd like to re-emphasize the point ·

Also, FWIW, I have never used the LEARN function·. Because the schemas and the MAME source code tell you a lot more than LEARN can.

Good luck.

(Iâm glad to hear that several people are using FIDE. Itâs possible in the future if the PODs get a software driver that Iâd update the software and fix a lot of things I wasnât happy with·.)

--James Bright
www.QuarterArcade.com
Restored Arcade Games for your Home

-----Original Message-----
From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of tony
Sent: Sunday, April 24, 2005 9:27 PM
To: Adam Courchesne; Technical Tools Mail List
Subject: Re: [Techtoolslist] sega outrun stuck in reset

i took a known good board set and tried the same thing running

fluke learn start 0 - ffff

i just get pod timed out

or pod timed out and reset when i hold the reset line high

and tried to get the outrun script from fide to run it will not go past address 0000

i did try to set trap active to "no" and pod just times out

has anyone ran a script on this board

i have 2 sets 1 good cpu and 1 bad cpu and 2 good video

the fluke does the same with the good and bad cup brd

on the good cpu board it will run the game with run uut

the bad just keeps resetting neither will let the fluke run

i did check the pod with a bus test (self test) it comes up fine

i must be missing something

any help ??

thanks tony
On Sun, 24 Apr 2005 18:42:33 -0400, Adam Courchesne wrote:
>> Hit setup on the 9010, hit more until you get to 'set trap active
>>
> force line' set it to 'no' .. no >need to disable WD.
>
> Assuming the reset signal is only used to reset the micro. If it
> goes to other registers, etc you could run into problems getting
> the board to run. -Adam ====================
> http://www.onecircuit.com ====================
> _______________________________________________ Techtoolslist
> mailing list Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist