Can anyone source the part that crimps to the
ribbon cable & provides a 40 pin dip socket? I could use some of
those!
Didn't see it in DigiKey, Mouser or
Allied.
(40pincclip.pdf has a sketch of the
part)
Kev
----- Original Message -----
Sent: Tuesday, April 01, 2003 2:45
PM
Subject: Re: Chip clip adapter for
9000
I think you could make something from Digikey's cables and
clips. I have a CPU clip I have experimented with (on a CAT Box), but not on
the System 80 MPUs with a 6502 Fluke pod. I don't know why, just never
did...however you do need to lift the two jumpers to disable the CPU (that's
what I did with the CAT Box - oh, I still have one CB for sale if anyone is
interested)...it might work, should not harm the CPU...perhaps the next MPU I
pull out I'll test this on and let you folks know the results, later this
week...
John :-#)#
At 12:45 PM 01/04/2003 -0500, James Bright
wrote:
Are
the clip adapters for the 9000 series pods still around? If I remember
correctly, Gottlieb soldered in the CPUs in the sys80 CPU boards. I'm going
to start working on some in the next few weeks. Just wondering how hard they
are to find and if people have used them with any success. I suppose I could
desolder the CPU, but if it's working, I'd rather
not.
JB
--James Bright
www.QuarterArcade.com
Restored
Arcade Games for your Home
How to subscribe or unsubscribe from TTL
To do either you
send email to "MajorDomo@flippers.com" and in the body you state either
"Subscribe techtoolslist" or "Unsubscribe techtoolslist", note that the
Subject is "" (Blank)...
FTP site is: ftp://ftp.flippers.com/TTL/