----- Original Message -----
Sent: Monday, April 25, 2005 2:26
AM
Subject: Re: [Techtoolslist] sega outrun
stuck in reset
i took a known good board set and tried the
same thing running
fluke learn start 0 - ffff
i just get pod timed out
or pod timed out and reset when i hold the
reset line high
and tried to get the outrun script
from fide to run it will not go past address 0000
i did try to set trap active to "no" and
pod just times out
has anyone ran a script on this
board
i have 2 sets 1 good cpu and 1 bad cpu and
2 good video
the fluke does the same with the good and
bad cup brd
on the good cpu board it will run the game
with run uut
the bad just keeps resetting neither will
let the fluke run
i did check the pod with a bus test (self
test) it comes up fine
i must be missing something
any help ??
thanks tony
On Sun, 24 Apr 2005 18:42:33
-0400, Adam Courchesne wrote:
>> Hit setup on the 9010,
hit more until you get to 'set trap active
>>
> force line' set it to 'no' ..
no >need to disable WD.
>
> Assuming the reset signal is
only used to reset the micro. If it
> goes to other registers, etc
you could run into problems getting
> the board to run. -Adam
====================
> http://www.onecircuit.com
====================
> _______________________________________________
Techtoolslist
> mailing list
Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist
_______________________________________________
Techtoolslist
mailing
list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist