Steve,
 
There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.
 
Best regards,
 
Filip
----- Original Message -----
From: Steve C
To: 'Technical Tools Mail List'
Sent: Monday, October 31, 2005 7:59 PM
Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

Yes, there is a panel on the back that allows voltage selection ö I canāt remember how but it was easy.


Steve

 

-----Original Message-----
From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
Sent: 31 October 2005 13:27
To: techtoolslist@flippers.com
Subject: [Techtoolslist] Fluke 9010A Input voltage

 

Hi all,

 

Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?

 

Best regards,

 

Filip

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist