Tony,

The script generator on the FIDE site is great. If you need to verify the memory map, you can hook up the 9010A, power up the known good board and hit the Learn key. It will ask you what starting address you want, type in 0 and hit the enter key. Then it will ask for the ending address, type in FFFF and hit the enter key. The 9010A will read the entire board to locate the RAM, ROM and input/output addresses. When the display says "Learn OK" hit the RAM button to show the ram locations, the ROM button to display the ROM locations and the I/O button to display the I/O locations.

Mark Hooks

850-894-8103

----- Original Message -----

From: tony

To: Technical Tools Mail List

Sent: Friday, April 22, 2005 11:09 AM

Subject: [Techtoolslist] fluke 9010a and sega outrun

i am not that good with the fluke scripts

can someone help setting up a fluke

with a fluke 9010a and 1 known good board (sega out run)

what is the best way to record the good board in the fluke 9010a

i have the rs232 on the back and fide and risk

through the 68000 and use it as a script to run it on a bad board (Sega out run)

or does anyone already have a script done for this

any help would be great

thanks tony

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________ Techtoolslist mailing list Techtoolslist@flippers.com http://seven.pairlist.net/mailman/listinfo/techtoolslist