There *must* be something on the outside, I bought two 9010aâs from the US and I certainly didnât open the case to change the voltage! My 9010aâs are in the garage loft at the moment, and thereâs a car in it so I canât drag either out to check!

Is there one of those rotate to voltage type things? Maybe itâs the 9100a that has a plastic cover and plug to change the voltage?

-----Original Message-----
From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
Sent: 31 October 2005 19:08
To: Technical Tools Mail List
Subject: Re: [Techtoolslist] Fluke 9010A Input voltage

Steve,

There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.

Best regards,

Filip

----- Original Message -----

From: Steve C

To: 'Technical Tools Mail List'

Sent: Monday, October 31, 2005 7:59 PM

Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

Yes, there is a panel on the back that allows voltage selection ö I canât remember how but it was easy.

Steve

-----Original Message-----
From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
Sent: 31 October 2005 13:27
To: techtoolslist@flippers.com
Subject: [Techtoolslist] Fluke 9010A Input voltage

Hi all,

Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?

Best regards,

Filip

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist