Philip: I guess you'll scan it in and make it available to everyone
as a few people requested, that would certainly be appreciated all round I'm
sure.
I
don't appear to have an extra D connector to plug into :-( Does anyone have
any schematics for this extra part? If nothing else, it'll be interesting to
take it apart and work out what it's doing, specifically the polynomial it uses
for calculation of the signatures. (If it's obvious how it's
done!)
The
Bug Trap that Kev mentioned would also be nice to see info on, if you have the
time. I now there were some standalone signature analyser boxes that were
available in the early 80's.
I saw
them in some magazine I was looking through at a collector's here in the UK. I
seem to recall they were retailing for about 400pounds. Some profit margin there
then!
Phil.
-----Original Message-----
From:
owner-techtoolslist@www.flippers.com
[mailto:owner-techtoolslist@www.flippers.com]On Behalf Of Philip
Mayor
Sent: 07 May 2002 14:09
To:
TechToolsList@flippers.com
Subject: Fluke clock
module.
It was known as the asynchronous signature probe
option and consisted of a special pcb installed in 9010 mainframe with an
extra d-sub connector on the front, the actual clock module, and a set of
special operating programs on a tape. There are five probes coming from the
clock module, they are: start, stop, clock, enable and ground.
Philip: I have original fluke info on this option
if you need it.
Thanks,
Phil.