So you are going into the business of Pod repair?
 
Good score!  Now if we could dig up some internal memos on the signatures/checksums.....
 
Kev
 

I have just been offered an interesting pile of test gear for the Fluke pods.

"1 each: 9000 series interface pod test fixtures for 6800 (6502), 8502, 8080, 8085, and Z80 pods.

These fixtures are used to verify proper operation of the 9000 interface pods. Each fixture

consists of test points for all uut cable lines, a rom to execute a 'Run UUT' program and a

divider  circuit to simulate power supply faults. The book has program listings and instructions

for use.

 

Also there is an incomplete z8 pod, 28 assorted test tapes including some factory diagnostics

a tape drive alignment fixture block, assorted pod cables in various states of bent pins."

So, when this all arrives I'll tell you more. I'm posting the pictures on the ftp site - no drooling!

ftp://www.flippers.com/Fluke and check the jpgs...

John :-#)#